Page 1 of 1

Oyo Imagesetter Issue

Posted: Mon Sep 26, 2011 2:12 pm
by jfirusta
Hello, new to the forums. I know this is technically a question for Oyo Instruments, but I can't seem to get ahold of a single person there, and our imagesetter is down. The problem is, it was working fine until today, I go through the steps like usual, but as soon as I send artwork to the actual imagesetter to be printed, all that comes out is blank film. This is an Oyo Instruments GS618 Thermal Imagesetter. I would be extremely grateful to anyone that can help. Thank you!

Rehttp://www.screenprintingforum.com/post: Oyo Imagesetter I

Posted: Tue Sep 27, 2011 6:18 am
by tompaine
I hate to help a competitor but...
does the internal test print out?
does it print out the correct length?

Re: Oyo Imagesetter Issue

Posted: Tue Sep 27, 2011 6:48 am
by jfirusta
Nope, everything acts normal except the film is blank, and I'm 99% sure it's not the film because we just bought this roll and I've output several pieces of artwork with it already, but I am going to test it anyways asap.

Re: Oyo Imagesetter Issue

Posted: Tue Sep 27, 2011 11:01 am
by tompaine
Just put a match under it to test.
Can you print a RIP test print from the PC?
Check the wires.