Page 1 of 1

Emulsion problems

Posted: Sat May 28, 2011 4:24 pm
by newbieshirts
Hi,

I am new and doing everything basic to start out with.
I am using emulsion sheets that I lay down on the screen.

After drying, I remove the top sheet from it and burn the image into it.

After the burn, the emulsion is like a hard plastic that I cannot remove with emulsion cleaner and also cannot print shirts with because it pulls up and is not clean.

Please help. What am I doing wrong? I think either I am using too much or too little water ont he screen. Drying the screen for too long or too short.

Any ideas?

TIA

Re: Emulsion problems

Posted: Thu Oct 13, 2011 3:34 pm
by d fleming
Tried some of those when sample was sent to shop. Just didn't like them. Stuck with my trusty ole bucket and scoop coater.