Page 1 of 1

Burning the emulsion post design

Posted: Wed Apr 22, 2015 4:44 pm
by silento
I'm working on a labeling project with 12 size bold font.

The emulsion that I'm using is the 280 tpi with Nazdar 9624 ink and Yudu Screen machine. The problem that I have is that I can get the ink to penetrate through well enough to get on my cables.

I would like to know if after I have burned an emulsion (5 minutes) and cleaned it with water to get my design. Can I go back and burn the emulsion again and clean it off to get a clearer imprint of the design?

Thank you,