Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Post your questions, suggestions, ideas and advice to issues you have run into in your screen printing shop.
Moderator: Moderator Team
theewizard
Just Browsing
Posts: 3 Joined: Mon Oct 02, 2006 9:40 am
Post
by theewizard » Mon Oct 02, 2006 9:51 am
i keep having breaks in the ABS pipe that drains my wash tank..
not at the joints as you'd think but in the middle of good runs of the pipe.. and parts have been replaced.. if it were faulty pipe..
i dunno what else to do.. were gonna replace with PVC but if not ...copper///$$$$$$$$...
any opinions??
specialty printing and techno djing..magick..
ROADSIDE
Administrator
Posts: 458 Joined: Fri Feb 24, 2006 4:36 pm
Location: South Jersey
Contact:
Post
by ROADSIDE » Mon Oct 02, 2006 1:47 pm
call the chemical manufacturer and see what they recommend to use.
You dont want to start adding metals because you dont know what the results may be.
.... I can give you my opinion but I can't tell you if it's right or not.
theewizard
Just Browsing
Posts: 3 Joined: Mon Oct 02, 2006 9:40 am
Post
by theewizard » Tue Oct 03, 2006 8:30 am
looked at all the sites.. and everything seems to be sewer system friendly..
but thanks..
specialty printing and techno djing..magick..